Institut Français des Sciences et Technologies des Transports, de l'Aménagement et des Réseaux

Type de document

ARTICLE A COMITE DE LECTURE REPERTORIE DANS BDI (ACL)

Langue

anglais

Auteur

ARCHEZ ; TEXIER-MANDOKI ; BOURBON ; CARON ; ROSSIGNOL

Résumé / Abstract

This work aims to shape a hollow cylinder with a geopolymer and an additive manufacturing process (3D printing) without organic additives. The formulation of a geopolymer composite using only mineral parts is proposed and the parameters of the 3D printing process were optimized. The mechanical properties, the microstructure, and the adhesion of the layers of the printing material were analysed and compared with the literature. The results showed that the geopolymer composite could be printed with the addition of small ratios of wollastonite, glass fibers, or non-reactive aluminosilicate and by modifying the printing speed. The stacking layers exhibited a good adhesion between them, avoiding the so-called ?cold joints? effect, and the fibers are flow-oriented during the process. Some hollow cylinders are successfully printed with a flexural strength of 15 MPa.

Source

Journal of Building Engineering, 101894 p.

  Accès à la notice sur le portail documentaire de l'IFSTTAR

  Liste complète des notices publiques de l'IFSTTAR